MTM 17-33
Heater MTM 17-33
Fuel:
- Vegetable oils,
- Raw vegetable oils (raps oil, sunflower oil, etc.)
- cooking oil
- Heating oil
- Diesel
- Vegetable oils,
- Raw vegetable oils (raps oil, sunflower oil, etc.)
- cooking oil
- Heating oil
- Diesel
Best places of use:
- Garrages,
- Warehouses,
- Car service premises,
- Workshops,
(Can heat up rooms up to 800 m3, if well insulated)
Characteristics:
- Stepless power regulation from,
- Protection against overheating,
- Protection against fuel overflow,
- LED diodes indicating operation status or possible emergency stop of combustion,
- Built-in control thermostat (the fan switches off when the furnace goes out when the temperature drops below 40 ° C within the combustion chamber),
- Thermostatic pump supervision,
- Durable casing covered with powder coating,
- Simple and failure-free controller,
- Powder coated fuel tank,
- Combustion chamber made of increased temperature resistant steel,
- 50 l fuel tank,
- Manual ignition,
- Blowing hot air in 3 directions,
- Maximum hot air outlet temperature 50-70 ° C (with indoor air temperature around 12 ° C).
- Blowing 1000 m3 / h of warm air (pressure ventilator).
Technical details:
| Standard package | Efficiency package | |
| Fuel consumption | from 1.7 to 3.3 l/h | from 1.3 to 2,9 l/h |
| Pressure fan (for heat distribution) | 1000 m3/h | 1000 m3/h |
| Nominal current | 0,8 A | 0,8 A |
| Electric power supply | 230 V / 50 Hz | 230 V / 50 Hz |
| Power consumption | 190 W | |
| Depth | 850 mm | 870 mm |
| Height | 1390 | 1390 |
| Width | 580 mm | 580 mm |
| Weight | 90 kg | 95 kg |
| Fuel tank | 50 l | 50 l |
Standard package versus Efficiency package
Efficiency package offers upgraded combustion chamber design. As a result a more independent and controlled combustion process is achieved giving higher efficiency and less fuel consumption for the same output setting.
Combustion air supply
In Standard package new air for combustion is supplied to the combustion chamber with the help of draft created by chimney.
In Efficiency package new air for combustion is specifically supplied above the furnace pan in the combustion chamber with the help of a pressure fan.
Efficiency package combustion process overall
The combination of a pressurized combustion chamber and pressure fan creates an environment allowing for intensified combustion process.
Efficiency package advantage
Because of previously mentioned things all across the output range a more efficient combustion process is guaranteed. This has resulted in a heater that is much less dependent on the chimney draft for combustion process. Plus it also helps the chimney draft if it is not sufficient.
The upgrades have resulted in a heater that not only has an increased power range, but also consumes less fuel in a given output setting.
Who is Efficiency package for?:
Mostly it is for those that want the maximum possible efficiency from this simple type of heating.
It is also for those that are willing to invest a bit more to have a heater which already worked well to begin with, but has been improved even further.
Additionally Efficiency package is for those that might not have enough draft in their chimney / flue pipe at all times.
Additional efficiency options:
Hot air economizer - If you want to:
- increase the efficiency of the device (up to 1200 m³),
- reduce the costs of heating or
- heating additional rooms,